Extron electronic Home Theater System P 2 DA2 User Manual

Setup Guide — P/2 DA2 Plus

This guide provides basic instructions for an experienced

installer to set up and operate the Extron P/2 DA2 Plus.

Installation

The P/2 DA2 Plus is a high performance, one input, two

output distribution ampliﬁer that accepts video input from

a VGA-QXGA compatible PC and distributes that signal to separately buffered outputs. See

the following application diagram.

Extron

P/2 DA2 Plus

VGA Distribution

Ampliꢀer

Projector

Installation and service must be performed by authorized personnel only.

Step 1 — Power down

Power off the display device, the PC and its local monitor.

Step 2 — Connect input

Connect the PC’s VGA output to the front panel input cable of the P/2 DA2 Plus distribution

ampliﬁer.

Step 3 — Connect outputs

•

Connect the PC’s monitor to the Local Monitor 15-pin HD output connector of the

distribution ampliﬁer.

•

Connect the display device to the Output 15-pin HD connector of the P/2 DA2 Plus.

Step 4 — Set DIP switches

Set the input and output impedance DIP switches:

Switch 1 (sync input impedance) – Default setting is down (510 ohms). If the image

from a laptop computer becomes unstable, slide the switch up (10k ohms).

OFF

Switch 2 (sync output impedance) – Default setting is up (50 ohms). If the front LED

is green and all the input and output cables are properly connected, but there is no

image at the projector, slide the switch down (75 ohms).

(Continued on reverse side.)