Coleman Tent 2000005512 User Manual

TENT SETUP INSTRUCTIONS

MODEL 2000005512

Before you begin

Read all instructions before set up.

• Select a level site clear of rocks, branches, and other hard or

sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

• Do not set up your tent under trees because of potential

lightning strikes or falling tree limbs in inclement weather.

• Secure with all stakes and guylines provided to prevent property

damage or personal injury.

• For best results in windy conditions, position narrow end of tent

into the wind.

• Do not drop tent.

Fig. 6

• Do not bounce tent bag on its end to remove tent, as these

actions may damage the frame.

• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO

PEOPLE TO ASSEMBLE.

• Under no circumstances should this product be used to cover

automobiles, marine products or similar items.

CAUTION: Avoid pinch points when opening and closing the

tent frame.

Extend the Tent Frame

Fig. 5

• Stand the tent upright with the hub assembly at the top. (Fig. 1)

• Unfold the arms of the tent downward until they lay flat on the

ground. (Fig. 2)

Verify Connections

between Tent and

Frame Poles

• Verify the clips along the edges of the tent are properly attached to the

frame poles. (Fig. 7 and Fig. 8)

Fig. 2

Fig. 1

Raise the Tent

• Unfold the arm joints located at each of the tent corners. The

tent will raise as the leg poles are extended. (Fig. 3 and 4)

• Extend each of the telescoping leg poles until they snap into

place. (Fig. 5 and 6)

Fig. 7

Pole

Clip

Fig. 4

Fig. 8

Fig. 3

(continued on other side)